Sponsors:

Recent

Online

720 Guests, 5 Users
Ianab, Brucer, chep, Ljohnsaw, Dave Shepard

Welcome to The 2025 Forestry Forum!

Do you have trees to grow? Logs to saw? A forest to manage? Chainsaws to fix? A sawmill to purchase or maintain? Timber related business to run? Lumber to dry? Trees or plants to identify? A cabin to build? Are you hungry and like FOOD?

Or would you just like to pull up a stump and visit with a friend?
If any of these and a multitude of other topics apply, then The Forestry Forum is the place for you.

What Will you Find on the Forestry Forum?

Pages: [1] 2 ... 40

LT70 drive belt tension

Posted in Sawmills and Milling
Yesterday at 09:37:25 PM
Written by KWood255
Views: 46
Hi all, on a periodic service last week my drive belt tension was a little under spec...12lbs approximately at 3/8" deflection. I engaged the auto clutch and began adjusting the treaded rod linkage to increase tension. I feel like I unthreaded (lengthened) the rod a long way to reach the 14lb spec. I was hoping to increase tension by a couple pounds to compensate for warmer belt temperatures/expansion but could not seem to get beyond 14lbs at 3/8". With this mechanical system I expected to be able to increase far above spec if ever needed. I'm only at 150hours total time on the mill. Anyone else experience something similar? I was reluctant to unthread the rod much more. Read More

0 Comments

Lonely mobile dimension mill

Posted in Sawmills and Milling
June 03, 2025, 09:01:23 PM
Written by chep
Views: 685
Hey Sawyers. I befriended a nice older lady today. She sold me a load of mulch hay. Told me the story of her late husband who died a couple years ago. One of his hobbies was sawing. Had a nice sawshed with a mobile dimension mill sitting in it. She said the gas in it had gone bad and the mill vw motor is "dead". Read More

7 Comments

RPM Gauge?

Posted in Sawmills and Milling
June 03, 2025, 09:22:17 AM
Written by mike dee
Views: 503
Anyone using RPM meter on their saws?

What I want to do is find a stand alone 12V DC RPM gauge that has a digital readout AND a digital output to control a device based on the detected RPM speed.

The alternative is to use a sensor for RPM and use something like an Arduino as the PLC to control relays.Read More

1 Comment

Timberframing and Bandsaw Cutting

Posted in Sawmills and Milling
May 31, 2025, 04:50:55 PM
Written by prittgers
Views: 786
Where can I find information on a band-sawing and timberframing class in Alaska this summer?

1 Comment

Woodmizer LT40SH CG-13 engine problem

Posted in Sawmills and Milling
May 31, 2025, 11:58:47 AM
Written by Country Bumpkin
Views: 718
I have a Wood-mizer LT40SH with a Nissan CG-13 engine that is not running right. I need to manually manipulate the choke to cold start it and it needs to really warm up before it will function properly. There is a small plastic gear on the throttle linkage with broken cogs that I suspect might be the...

Read More

1 Comment
Pages: [1] 2 ... 40

Thank You Sponsors!