Sponsors:

Recent

Welcome to The 2025 Forestry Forum!

Do you have trees to grow? Logs to saw? A forest to manage? Chainsaws to fix? A sawmill to purchase or maintain? Timber related business to run? Lumber to dry? Trees or plants to identify? A cabin to build? Are you hungry and like FOOD?

Or would you just like to pull up a stump and visit with a friend?
If any of these and a multitude of other topics apply, then The Forestry Forum is the place for you.

What Will you Find on the Forestry Forum?

Pages: [1] 2 ... 40

Need some advice

Posted in Sawmills and Milling
Yesterday at 09:47:42 PM
Written by Bearpau
Views: 426
I'm thinking about selling my lt28 band mill is there a place to get a reasonable value from? I called Woodmizer and I'm not real confident the gentleman knew what he was talking about.

5 Comments

"pretzel" packed blades

Posted in Sawmills and Milling
June 05, 2025, 09:21:51 AM
Written by JP Wazz
Views: 1952
when i bought my saw it came with a box of 15 blades packed in a cardboard box. i store them inside so the blades won't get wet/rusty. i noticed when putting on a new blade today that out of the box the new blade has a rather pronounced bend in it from the packaging method used by the blade maker....

Read More

10 Comments

LT70 drive belt tension

Posted in Sawmills and Milling
June 04, 2025, 09:37:25 PM
Written by KWood255
Views: 1771
Hi all, on a periodic service last week my drive belt tension was a little under spec...12lbs approximately at 3/8" deflection. I began adjusting the treaded rod linkage to increase tension. I feel like I unthreaded (lengthened) the rod a long way to reach the 14lb spec. I was hoping to increase tension by a couple pounds to compensate for warmer belt temperatures/expansion but could not seem to get beyond 14lbs at 3/8". With this mechanical system I expected to be able to increase far above spec if ever needed. I'm only at 150hours total time on the mill. Anyone else experience something similar? I was reluctant to unthread the rod much more. Read More

9 Comments

Lonely mobile dimension mill

Posted in Sawmills and Milling
June 03, 2025, 09:01:23 PM
Written by chep
Views: 1867
Hey Sawyers. I befriended a nice older lady today. She sold me a load of mulch hay. Told me the story of her late husband who died a couple years ago. One of his hobbies was sawing. Had a nice sawshed with a mobile dimension mill sitting in it. She said the gas in it had gone bad and the mill vw motor is "dead". Read More

7 Comments

RPM Gauge?

Posted in Sawmills and Milling
June 03, 2025, 09:22:17 AM
Written by mike dee
Views: 1251
Anyone using RPM meter on their saws?

What I want to do is find a stand alone 12V DC RPM gauge that has a digital readout AND a digital output to control a device based on the detected RPM speed.

The alternative is to use a sensor for RPM and use something like an Arduino as the PLC to control relays.Read More

1 Comment
Pages: [1] 2 ... 40

Thank You Sponsors!