iDRY Vacuum Kilns

Sponsors:

Hydro axe 321 issue

Started by Stumpjumper76, October 17, 2017, 02:25:03 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Stumpjumper76

I hope this is ok to post here. If not please direct me to the proper spot. We have a hydro axe 321 cutter that has been giving us fits. It runs fine for a while then all hydraulic functions stop working. Checked the pilot pressure and it's at 320psi. While driving with the gauge attached during a failure the psi dropped to nearly zero but we can't figure out why.

The reason I'm posting is we have literally had 3 different opinions from shops in our area and they're all pointing in different directions. If anyone has experienced this type of event and have some advice I'm all ears. Thanks in advance and a huge thumbs up to this forum. Love all the threads and info.

Aaron

Thank You Sponsors!