iDRY Vacuum Kilns

Sponsors:

Quick question on adjusting ms362 carb

Started by Woodcutter_Mo, September 16, 2017, 03:25:34 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Woodcutter_Mo

  I need to adjust the sacb on my dad's early ms362. This carb only has the red limiter cap on the H screw.

I got the cap out, now to what is the next step? Do I trim the tab off and reinstall it? Or should that simply let the tab fall out?

Next question is what is the PN for a new tab? This one is a little messed up. Thanks
-WoodMizer LT25
-592XP full wrap, 372XP, 550XP, 455 Rancher, RedMax GZ3500T
-Fixer-uppers/projects:
024AV, MS260, MS361, MS460, Shindaiwa 488, 394XPG

HuckFin

Trim the tab off. Don't know the part# for the plastic limiter.

Texas-Jim

Part # 4203 121 2700 The adjustment screw doesnt have a spring on it and they often vibrate out or in without the limiter. its 2 bucks.
What we do in life echoes through eternity.

Woodcutter_Mo

 Thanks for the info. I trimmed the tab off but got to thinking about it that the limiter cap may just rattle out with the tab gone. Is that correct? Thanks for the part number as well.
-WoodMizer LT25
-592XP full wrap, 372XP, 550XP, 455 Rancher, RedMax GZ3500T
-Fixer-uppers/projects:
024AV, MS260, MS361, MS460, Shindaiwa 488, 394XPG

John Mc

Quote from: Woodcutter_Mo on September 16, 2017, 10:17:41 PM
Thanks for the info. I trimmed the tab off but got to thinking about it that the limiter cap may just rattle out with the tab gone. Is that correct? Thanks for the part number as well.

It's generally not a problem if you just trim the tab. The plastic cap and spring seem to keep it from drifting. If you just remove the cap and spring altogether, it will tend to drift.
If the only tool you have is a hammer, you tend to see every problem as a nail.   - Abraham Maslow

Thank You Sponsors!