iDRY Vacuum Kilns

Sponsors:

broke energy chain

Started by xlogger, August 02, 2017, 05:57:59 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

xlogger

Did something stupid again yesterday, got in a hurry load short log on mill and didn't take time to get out of bobcat to raise back stops. I've set them on there several times before like that but this time log rolled off back of mill onto energy chain. Snap a connection loose. I've watch a couple videos on igus in Youtube this morning and they make it look simple but they put one together with no hoses in it and they turn it upside down to make repairs. Where it broke at it will be  hard to get to bottom side. Has anyone repair one and have an easier idea? I can run the mill, chain gets out of the runner it set in but falls back in as the mill gets to other end.
Timberking 2000, Turbo slabber Mill, 584 Case, Bobcat 773, solar kiln, Nyle L-53 DH kiln

Thank You Sponsors!