Replacing the bandwheel bearings

Started by mattyo5, February 28, 2017, 10:35:04 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

mattyo5

Just did a vid on replacing the bandwheel bearings.  I noticed a vibration as I sped up the mill, and as it came back to a stop ...  like something was wobbling.  I guessed that it was the non-driven side.  I was right.   Haven't run it yet this season, just did this a couple days ago.   Need TWO bearings per bandwheel.   SKF 6305 2RS 1C3 is the part you need. 

https://youtu.be/8YDQdnIepKE

gonna post this in the general sawmill forum too
Woodland Mills HM126 Sawmill - modded
Husqvarna 385xp rebuilt and ported
Husqvarna 372xp rebuilt and ported
2x Husqvarna 350 ...rebuilt and ported
Hitachi CS33etdb top handle saw

mattyo5

Woodland Mills HM126 Sawmill - modded
Husqvarna 385xp rebuilt and ported
Husqvarna 372xp rebuilt and ported
2x Husqvarna 350 ...rebuilt and ported
Hitachi CS33etdb top handle saw