Husqvarna 390xp rebuild

[Mark1997]

Hi everyone I have a Husqvarna 390xp that I am currently building. I am from Australia and OEM parts are very expensive so I am looking at using an aftermarket cylinder and piston. I have ordered a crank from Huztle on EBay and ordered bearings from my local bearing supplier. I will take a few photo's of the saw and its current state. Any help on a decent aftermarket top end would be greatly appreciated.

[Cut4fun]

Must be who they started the thread on another place asking for. Here is the info I posted there already.

If I had gotten the used 385 I was going to try a afm 390 topend. But guy in front of me took it.

I was going to try this one. $129   http://www.hlsproparts.com/Husqvarna-390-cylinder-kit-p/h30391.htm

Get 10% of using code  in their where to buy online thread too on that site. I also would have gotten my crankshaft kit from them too so I would have a warranty of some kind.