iDRY Vacuum Kilns

Sponsors:

Five foot diameter hard maple!!!!!

Started by KDEC19, August 15, 2004, 01:05:37 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

KDEC19

Hey all just scored this huge hard maple.  On old main st!!  Wanted to find out which way to reduce to get home to the mill.  Or even get on the mill!!!    I was thinking of guartering it through the heart.  Then I can get these pieces trimed up later.  Thanks much.  Quick reponse is needed due to homeowners schedule.  Thanks much.
gonna do it again......

MemphisLogger

If you do quarter it through the heart (I would), get it sawn as quick as possible since it will immediately start to stain and check. Good luck!  
Scott Banbury, Urban logger since 2002--Custom Woodworker since 1990. Running a Woodmizer LT-30, a flock of Huskies and a herd of Toy 4x4s Midtown Logging and Lumber Company at www.scottbanbury.com

Captain

Geez, I drove right through Hartford with the Peterson the other day  ::)

Captain

Captain

Geez, I drove right through Hartford with the Peterson the other day  ::)

Captain

Thank You Sponsors!