iDRY Vacuum Kilns

Sponsors:

WM open house - Mt. Vernon, MO April 18, 2009

Started by Bibbyman, April 18, 2009, 09:08:51 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Bibbyman

 



Arky, R-May, LeeB,  what is your excuse?   You were AWOL at the Wood-Mizer open house in Mt. Vernon today.

There was a good crowd of people show up to look at Wood-Mizer's full range of mills – all were represented except for an LT28 – they didn't have one available.

I hear the LT10s and LT15s are flying off the shelf – even in this economy.  There were a lot of interest in the small mills at the show today and I think more were sold than they had on hand.

A couple of us wanted the new 7 degree blades but although they had planned to have boxes of them available, they were out of stock.

Mary and I went down on Friday and dropped off about 40 blades to be re-sharpen.  I figure the amount saved on the shipping about paid for the gas.  'Corse, it didn't pay for the eats, motel room and two days off.  But it was a valuable trip none the less.  We visited with old friends and found out what's going on in other parts of the country.


Wood-Mizer LT40HDE25 Super 25hp 3ph with Command Control and Accuset.
Sawing since '94

Thank You Sponsors!