iDRY Vacuum Kilns

Sponsors:

Proud owner of Q3- need help

Started by HOOF-ER, August 20, 2008, 05:50:06 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

HOOF-ER

I just got home with an almost new Delta Q3. I have been looking for scroll saws for some time. This one showed up on Craigslist. Couldn't pass up for $75. Now the down, I noticed the lower blade holder is moving left or right. Was this set up wrong? I was thinking of putting little washers on either side of the blade holder to get it square. Anyone got experience with these? Sure is smooth compared to the old craftsman .
Home built swing mill, 27hp Kawasaki

Thank You Sponsors!