iDRY Vacuum Kilns

Sponsors:

Jonsered 630 ,runs and dont run

Started by KamHillbilly, September 03, 2006, 04:46:26 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

KamHillbilly

September 03, 2006, 04:46:26 PM
My saw runs when it wants to ,I'll cut a log or two shut saw off move cut wood go to start up again it fires then nothing .Leave it sit (hour or so) Fires up then same thing again.Any ideas , I also have a 670 Champ that has a bad vibration are these saws hard to rebuild ? Is there a good site to find parts diagrams and rebuild info ?Thanks in advance
Homemade Bandmill ,Clark 664b ,Case 780b ,Jonsered 670,630

ladylake

#1
September 03, 2006, 05:53:31 PM
Maybe has a leaky, dirty needle valve letting it load up with fuel when sitting for a couple of minutes.  Try holding the throttle wide open when your starting it.    Steve
Timberking B20  18000  hours +  Case75xt grapple + forks+8" snow bucket + dirt bucket   770 Oliver   Lots(too many) of chainsaws, Like the Echo saws and the Stihl and Husky     W5  Case loader   1  trailers  Wright sharpener     Suffolk  setter Volvo MCT125c skid loader

Kevin

#2
September 04, 2006, 07:49:24 PM
Could be the coil heating up and going open.
Check for a spark when it won't start.

KamHillbilly

#3
September 04, 2006, 08:47:48 PM
thanks I'll check it out in the morning
Homemade Bandmill ,Clark 664b ,Case 780b ,Jonsered 670,630

4woody

#4
September 04, 2006, 09:48:52 PM
CHEK THE VENT line it has a chek vave on it i had to fix it on mine

micky boy

#5
September 05, 2006, 06:10:25 PM
Check out this site. Jonsered 630 IPL's
This is his main site Jonsered/Husqy saws parts man, etc.
Three Five Seven............Chainsaw Heaven

KamHillbilly

#6
September 06, 2006, 06:08:50 PM
Thanks now I have to find time to check it out
Homemade Bandmill ,Clark 664b ,Case 780b ,Jonsered 670,630
Print
Go Up Pages1
User actions

Thank You Sponsors!